2. Record a scene with 1 or more steps (see above)
3. If you are not satisfied with the scene(s), you may press and hold the Record button and tap the
Page/REC CLR button. All LEDs will flash, indicating that the scenes have been cleared.
NOTE:
This function will erase all data stored in the temporary memory. This process will not affect any
stored scenes or programs, which have a position on the controller.
Delete a step or multiple steps
1. Enter the EDIT mode (see above)
2. Tap the Step button to scroll to the step you wish to delete
3. Tap the Delete button when you have reached the step.
4. Repeat steps 2 and 3 until you are satisfied with the result
5. Press and hold the REC Exit button. The Scene Button LED will turn off, indicating that you are out of the
Edit mode.
Insert a step or multiple steps
1. Record a scene or multiple scenes you wish to insert, into the temporary memory
2. Be sure you are in the Chase <> Scene function and enter the EDIT mode
3. Tap the Step button to scroll to the step you wish to insert the steps
BEFORE
. You can use the display to
determine at which step you currently are.
4. Tap the Insert button to insert the step(s) you just created before
5. Exit the EDIT mode.
NOTE:
See above for more information about entering the EDIT mode
Modify a step or multiple steps
1. Enter the EDIT mode (see above)
2. Tap the Step button to scroll to the step where you wish to edit.
3. While holding the UP or DOWN button, tap the Flash button corresponding to the DMX channel of the
scene you wish to modify until you reach the desired intensity. Check the value of the channel on the display.
Tap the Flash buttons until every channel has the proper new value.
4. Repeat step 2 and 3 until you are satisfied with the result
5. Exit EDIT mode
NOTE: All LEDs will flash, to indicate a successful insert of the new values
Practical information about playback
This controller uses the Channel Faders and Flash Buttons for multiple purposes. Channel faders 13-24 (37-
48) are used to playback scenes that are already recorded, only in Chase<>Scene mode! In this mode,
Master Fader A will control the manual fader controls of the first 12 channels, while Master Fader B will
control the scenes which are played back.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0
Creation date + author initials: 29-03-2014 RV Revision date + author initials: 29-03-2014 RV