Operation and Mounting
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
The device cannot be operated while it is still starting up. Once the device has fully started up, it will
automatically jump to the last mode and setting. Operation modes and other settings shown on the display
can now be adjusted or changed via the menu buttons.
If a DMX signal is detected, the device shall automatically switch to DMX mode and the DMX address that
was last used. For a new device, this is usually DMX address 001. The DMX address can of course be
changed via the display and menu buttons.
The functions, modes and settings can be changed by using the display and menu buttons. Push ‘Enter’ to
select a function or to confirm a change. Push ‘Up’ and ‘Down’ to change any values and push the ‘Menu’
button to return to the main menu.
The Menu includes the following options and fuctions:
Menu
Function
Settings and Values
DMX Settings
DMX Address
001-512
DMX Channel Mode
Mode 1 (17)
Mode 2 (20)
DMX State (DMX status at signal loss)
Master / Slave
Blackout
Hold
Fixture Settings
Pan Inverse (horizontal movement mirroring)
Yes / No
Tilt Inverse (vertical movement mirroring)
Yes / No
Pan/Tilt Feedback
Yes / No
Dimmer Curve
Linear
Square Low
Inverted Square Low
S Curve
Show Focus
5m
10m
15m
Show Settings
Show Mode
Show 1-4
Slave Mode
Master
Slave 1
Slave 2
Sound Sense
0-100
Display Settings
Display Inverse (flip display)
Yes / No
Contrast Ratio Display
0-30
Unit Temperature Display
Displays temperature in
degrees Celsius
Language
English / Chinese
Fixture Test
Auto Test
Automatic walk-through test
mode
Manual Test
Manual test mode
The information shown in this user manual could be subject to change without further notice.
Version: 1.1
Date of creation and initials of author: 07-10-2019 RV
Date of revision and initials of author: -
