COMPONENT LIST
PREPARATION
87
86|
GB
The declared vibration emission level represents the main applications of the tool. However
if the tool is used for different applications, with different accessories or poorly maintained,
the vibration emission may differ. This may significantly increase the exposure level over
the total working period.
An estimation of the level of exposure to vibration should also take into account the times
when the tool is switched off or when it is running but not actually doing the job. This may
significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibration
such as: maintain the tool and the accessories, keep the hands warm, organisation of
work patterns.
Handle Setup
Open out the handle and screw the handles parts with the four screws and knobs. Put the
recoil starter on the right of the handle and fix the cable with the plastic collar. Introduce
the rope of recoil starter handle or its support guide rope. (See Fig. 1)
Handle bar height position adjustment:
1.If you want to adjust height of the handle bar, you can choose” L” or “H” two holes
In left-right Bracket to fix the handle bar with screws and knobs.
2. The “H” hole is high position of the handle bar, and the “L” hole is low position of the
handle bar. (See Fig. 2
）
1
2
3
4
5
6
7
8
9
10
11
12
Clutch lever
Brake lever
Knob
Rear discharge guard
Fuel tank
Air filter
Deck
Oil dipstick
Height Adjust handle
Grass bag
Rope guide
Start handle
1
2
3
4
5
6
10
11
12
9
8
7
Blade Washing Hole
CABLE SETUP – ENGINE BRAKE & SELF-PROPELLED LEVER
1. Insert the brake cable and clutch cable in to the hole of appropriate lever, see the
illustration below.
2. The arrow indicates where the cable should loop through.
（
See Fig. 3)
Fig. 1
Fig. 2
Fig. 3
Drive Cable
Engine Brake
Cable
