3
REV. 10/8/21 INSTAXTC-FD3
PROGRAMMING
1.
Open the driver’s door, and keep open during the programming process.
2.
Cycle the ignition on and wait (5) seconds.
3.
Connect the
AXTC-FD3 harness
to the
AXTC-FD3 interface
, and then to
the wiring harness in the vehicle.
4.
Locate the
Volume Up
button on the steering wheel. Program the interface
by tapping the
Volume Up
button at a heartbeat pace until the LED light
stops flashing.
5.
The LED light will flash
Green
&
Red
while the interface programs the
radio to the steering wheel controls. Once programmed, the LED light will
go out, then produce a pattern which will identify the radio type installed.
6.
The LED light will go out, then once again quickly flash
Green
&
Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid
Green
.
7.
Cycle the ignition off, then back on.
8.
Test all functions of the installation for proper operation.
Green & Red LED
Green or Red LED
Green & Red LED
Green LED
OF
F
ACC
ON S
TAR
T
OF
F
ACC
ON S
TAR
T
OF
F
ACC
ON S
TAR
T
VOL
+
Tap Volume Up
