Axxess ASWC-1, Руководство по установке

Страница: 11 / 48

11
Note: Not every radio will have all the possible SWC commands
on the steering wheel. Aftermarket radios that do not have Bluetooth
will not recognize the PTT (Push To Talk) or “On/Off Hook”
commands; however those buttons can be manually programmed
to do other commands in some cases. Please refer to the radio
owner’s manual or wireless remote for specific commands that the
radio will recognize.
1) Complete connections to the vehicle and to the aftermarket radio,
make sure the 3.5mm connector is connected.
If this is the first time the ASWC-1 is being installed in a vehicle:
2) Turn the ignition on; the LED will start flashing rapidly.
3) After 10 seconds the ASWC-1 will go into the LED feedback mode.
After the series of LED flashes the LED will stay in a slow constant
flash state. Go to step 4.
--- Or ---
If the ASWC-1 has been in a vehicle before:
2) Press and hold the reset button down for more then 10 seconds.
3) After the 10 seconds the LED will begin a slow constant flash.
4) At this point press and hold the “Volume Up” button on the steering
wheel for 7 seconds until the LED goes solid red. Now release the
“Volume Up” button and the LED goes “Off”. “Volume Up” has now
been programmed.
Section 3: Troubleshooting