Axxess ASWC-1, Руководство по установке

Страница: 20 / 48

20
Dual Assignment Instructions
Note: Seek up and Seek down are already set to Preset up and
Preset down for long press.
1) Turn on the ignition but do not start the vehicle.
2) Press and hold down the steering wheel button that you want to
assign a long press function to, for about ten seconds until the LED
rapidly flashes green. At this point release the button and the LED
will go solid green.
3) Press and release the VOLUME UP button the number of times
corresponding to the new button number you selected (see chart
below). The green LED will blink rapidly when the VOLUME UP is
pressed and back to solid green when released. (Caution, if more
than ten seconds elapses between a VOLUME UP button press, this
procedure will abort, and the LED will go off). Go to the next step
when the VOLUME UP button has been pressed the desired
number of times.
4) To store the long press button in memory, press the button that you
assigned a long press button (the button held down in step 1). The
LED will now go off indicating it has been stored.
Note: These steps must be repeated for each button you would like
to assign dual purpose action to.
To reset a button back to its original use, repeat step 1 above. Then
press the VOLUME DOWN button. The LED will go off and the long press
mapping for the button will be erased.