Axon Body 3 Dock
Installation Manual
Axon Enterprise, Inc.
Page 21 of 25
To prevent potential injuries, leaking, overheating or explosion of batteries, take the
following precautions:
1.
Do not replace the batteries in the Axon Flex system, Axon Flex 2 system, Axon
Body camera, or Axon Fleet power unit.
The batteries in the Axon Flex system, Axon
Flex 2 system, Axon Body camera, and Axon Fleet power unit are not designed to be
replaced. DO NOT attempt to replace these batteries. The Axon Body 2 and Axon Body 3
camera batteries are replaceable only with Axon-approved batteries.
2.
Avoid extreme temperatures.
Do not expose the battery to excessive heat, cold, water,
other liquids, or corrosive substances. Do not use or leave the batteries for on-officer
cameras near a heat source or at a very high temperature (for example, fire, heater, in
strong direct sunlight, or in a vehicle in extremely hot weather). Otherwise, the battery
may overheat, cause a fire, or its performance will be degenerated and its service life will
be shortened. The battery in the Axon Fleet power unit is designed to be installed in the
passenger compartment of a vehicle. Do not install the Axon Fleet power unit in the
engine compartment, on the exterior of a vehicle, or in any location that will continually
expose it to direct sunlight, water, other liquids, or corrosive substances.
3.
Avoid
static electricity.
Keep the battery away from sources of static electricity. Static
electricity can cause damage to the battery, which could result in serious injury.
4.
Recharging.
When recharging Axon equipment, use the Dock or Axon-approved power
source specifically for that purpose. Do not reverse the positive
(+) and negative (−)
terminals. Do not connect the battery to an electrical outlet without using an Axon-
approved adapter. The Axon Fleet power unit is designed to be recharged when the
vehicle’s engine is running. Do not attempt to recharge the Axon Fleet power unit by
other means.
5.
Handling.
Ensure proper connections between the Axon equipment when charging or
docking an Axon component. To avoid risk of fire, burns, or damage to your battery
pack, do not: allow a metal object to touch the battery contacts; strike or throw the
battery; directly solder the battery or pierce the battery with a nail or other sharp object;
disassemble, short circuit, or heat batteries; or put batteries in a fire. Doing so may
cause battery explosion, battery leakage, system damage, injury, or fire.
6.
Abnormal appearance.
If the battery gives off an odor, generates heat, becomes
discolored or deformed, or in any way appears abnormal during use, recharging or
storage, immediately place the Axon component with the battery in a contained vessel
such as a metal box.
7.
Avoid battery acid contact with skin or eyes.
In case the battery acid gets into the
eyes due to the leakage of battery, do not rub the eyes. Rinse the eyes with clean
