Axminster ATDP13B, Руководство пользователя

Страница: 6 / 32

General Safety Instructions for Drilling Machines
6
1. DO NOT operate the machine without carrying out
a preliminary inspection.
2. CHECK that the speed is correct for the planned operation,
and the upper drive belt cover is closed and fastened secure.
3. CHECK the drill bit is the correct size and type, is correctly
fitted and tightened in the chuck.
4. Make sure that the drill head, the table bracket arm, the table
tilt and the table swivel clamps are all locked before any drilling
is attempted.
5. DO NOT attempt to carry out any drilling operation on
material that has not been secured to the drill table, either by
vice or clamp.
6. Remove any tools (chuck key, spanners etc), that may have
been used in setting up operations and put them away in their
correct stowage positions.
7. Try to arrange the drilling operation so that the drill tip does
not come in contact with the table.
8. ALWAYS allow the drill to stop before removing drills or
swarf from around the job or the table.
9. NEVER remove ‘flying’ swarf strands from the drill whilst it is
turning.
10. It is a good precaution to wear eye protection when drilling,
especially using small drills, or very hard material that produces
small chips.
11. It is not a good idea to wear gloves when operating a drill
press.
12. After the job is completed, remove all tools and accessories
from the machine, check that drill bits are still sharp and re-use
able.
13. Clean the machine down thoroughly, including removing
coolant or cutting compounds from the drill table.
14. Lightly coat all metal surfaces with a light oil coating.
15. Disconnect the machine from the supply. Secure the cable/
plug clear of the floor.