Axminster ATDP13B, Руководство пользователя

Страница: 20 / 32

Maintenance
20
WARNING! DISCONNECT THE MACHINE
FROM THE MAINS SUPPLY BEFORE
CONTINUING!
Cleaning
Excessive dust in the motor can cause excessive heat to
develop. Every effort should be made to prevent foreign
material from entering the motor.
When operated under conditions likely to permit accumula-
tions of dust, dirt or waste, a visual inspection should be made
at frequent intervals. Accumulations of dry dust can usually be
blown out successfully.
Caution: To avoid eye injury or adverse reaction to dust,
high pressure hoses should not be used especially in poorly
ventilated areas. The operator performing this cleaning
function should wear safety goggles and dust filter mask.
After cleaning, apply a light coat of machine oil on the quill
and chuck.
If the machine is going to stand idle for any length of time, a
light coat of spray or machine oil over the column and table
will prevent rusting. Then place a dust sheet over the pillar drill.
Electric
WARNING! DO NOT USE THE MACHINE
IF THE POWER CABLE HAS BECOME
DAMAGED.
If any servicing (other than the above cleaning) becomes
necessary, the unit should be returned to Axminster Tool Centre
to be repaired by one of our qualified electricians. Contact our
customer sales department for further assisance on 03332
406406 or email as @ csaxminster.co.uk .
Call: 03332 406406
Email: cs@axminster.co.uk
WARNING! DO NOT ATTEMPT TO REPAIR
IT YOURSELF CONTACT OUR TECHNICAL
SALES TEAM FOR ASSISTANCE.
The speed of the motor cannot be regulated or changed - no
adjustment is necessary.
Motor speed
Oil Points