Axminster ATDP13B, Руководство пользователя

Страница: 10 / 32

Assembly
10
Mounting the Drill Head
WARNING! THE DRILL HEAD IS A HEAVY
AND SUBSTANTIAL PIECE OF MACHINERY,
YOU ARE ADVISED TO HAVE HELP TO LIFT
IT CLEAR OF THE BOX AND FIT IT TO THE
COLUMN.
1. CHECK the drill head, ensure that the two hex socket grub
screws that lock the head in place on the column are withdrawn
and will not foul on the column when the head is fitted, see
fig 17. Place the assembly you have just been working on in
the designated position, make sure it is stable and lift the
drill head over the column and let it drop into place, see fig 18.
Set the drill head approximately fore and aft and lock in
position using the two cap head grub screws mentioned earlier,
see fig 19. Check that the drill head is immobile. Everything on
the drilling machine is now secured.
Fig 17-18-19
2. Locate the lever feed handle and its securing cap head
bolt/washer (9), note the raised boss and spigot on feed
mechanism. Mount the handle over the boss and ensure
the spigot slots into the pre-driiled hole in the feed handle
assembly. Secure with the supplied cap head bolt through the
hole in the centre of the handle, through into the tapped hole
in the mounting boss, see fig 20-21-22-23.
Fig 20-21-22-23
Fig 13-14-15
7. Screw in the remaining lift and shift handle (8) into the threaded
hole to the end of the mounting arm. Lower the drill table (4,4a,4b)
spigot into the machined hole to the front of the mounting arm and
tighten the handle until it has ‘pinched’ up on the drill table’s spigot
and the table is immobile, see fig 13-14-15.
Lever Feed Handle
8
Grub screws
3
Raised boss
Spigot
Pre-drilled hole
tapped hole
4
4a
4b