Axminster 107715, Оригинальное руководство пользователя, Страница: 30 / 52

Setting Up the Machine
30
Fig 101
Feeler gauge
3. Place a rule across both tables and measure the
distance between both ‘T’ slots, do the same to the
opposite end and check the distances are the same, see
fig 102-103. If there is any deviation between the ‘T’ slots
repeat step 2 and check again.
Figure 102-103
Sliding table ‘T’ slot
Main table ‘T’ slot
4. Once correct, tighten nuts on the supporting brackets
to the underside of the sliding table to lock the setting,
see fig 100.
Sliding Table Height
Place a straight edge across both tables. Loosen the two
clamping bolts on the support brackets beneath the
sliding table, see fig 104. Adjust the rise full Hex bolts by
loosening the locking nut, see fig 105 and adjust until
the sliding table (10) is level with the main saw table.
Once level, re-tighten the nuts to secure the setting.
NOTE: Check that the sliding table is still level with
the main table as it may have shifted when tightening
up the bolts.
Fig 104-105
Table height Hex bolts
and locking nuts
Clamping bolts
Setting the Riving Knife Gap
1. Raise the saw blade up to it’s maximum height and
remove the crown guard assembly.
2. Check the clearance between the riving knife and
the saw blade, it should have a gap of (MIN 3mm - MAX
8mm), see fig 106.
12
3-8mm Gap
between the
riving knife
and the blade
Clearance
Fig 106
3. If adjustment is required, move the sliding table to one
side, remove the two Phillips screws holding the inner
guard assembly and place safely aside, see fig 107.