Axminster 107655, Оригинальное руководство пользователя

Страница: 6 / 60

ASSEMBLY INSTRUCTIONS
6
Please take some time to read the section entitled
“Illustration & Parts Description” to identify the
various parts of your machine so that you are familiar
with the terminology we will use to enable you
to set up and operate your table lathe safely and
correctly.
The machine and its accessories will arrive coated
with corrosion preventative grease. This will need to
be cleaned from the machine, its components and
accessories prior to it being set up and
commissioned. Use coal oil, paraffin or a proprietary
de greaser to remove the barrier grease. Be warned,
it will stain if you splash it on clothing etc., wear
overalls, coverall et al., rubber gloves are also a good
idea, as is eye protection if your cleaning process
tends to be a little bit enthusiastic. After cleaning,
lightly coat the machine with a thin layer of light
machine oil. N.B If you used paraffin/kerosene make
sure you apply this thin film sooner rather than later.
95% of the machine comes fully assembled, (See
what’s included) to assemble the remaining 5%
please follow the instructions below.
Assembling the Carrying handles
Locate the two steel carrying handles (E) and the four
1/4 unc x 5/8" Phillips screws, attach them to each
end of the lathe bed (See figure 1).
Figure 01
E
Locate the two steel hooks & Phillips screws (G) and
screw them with the hooks facing inwards, into the
pre-drilled holes in the lathe bed. (See figures 2-3)
Assembling the Power Cable Hooks
Figure 02
Pre-drilled holes in lathe bed casting
Figure 03
Steel hook
Figure 04
Steel hooks in position
Remove the motor door securing screw and open
the door by pulling it towards you. Connect the
connector socket cables (See figure 4)