Axminster 107655, Оригинальное руководство пользователя

Страница: 5 / 60

GENERAL INSTRUCTIONS FOR 230V MACHINES
5
Code 107655
Model AP350WL
Rating Professional
Power
230V 50Hz 750W
Speed L = Low 80-800, M = Medium 170-1700, S = High 350-3,700rpm
Spindle Taper 2 MT
Spindle Thread M33 x 3.5mm (Ref T38)
Taper Tailstock 2 MT
Distance Between Centres 400 mm
Max Diameter over Bed 350 mm
Tool Rest Stem Diameter 25.4 mm
Overall L x W x H 865 x 330 x 415mm (With Extension Bed: 1,465 x 330 x 415 mm)
Weight 41 kg
SPECIFICATION
Make sure you are comfortable before you start work,
balanced, not reaching etc.
If the work you are carrying out is liable to generate
flying grit, dust or chips, wear the appropriate safety
clothing, goggles, gloves, masks etc. If the work
operation appears to be excessively noisy, wear
ear-defenders. If you wear your hair in a long style,
wearing a cap, safety helmet, hairnet, even a
sweatband, will minimise the possibility of your hair
being caught up in the rotating parts of the tool, likewise, consideration should be given to the
removal of rings and wristwatches, if these are liable
to be a ‘snag’ hazard. Consideration should also be
given to non-slip footwear, etc.
DO NOT work with cutting tools of any description if
you are tired, your attention is wandering or you
are being subjected to distraction. A deep cut, a
lost fingertip or worse; is not worth it! Above all,
OBSERVE…. make sure you know what is happening
around you, and USE YOUR COMMON SENSE.
SPECIFIC SAFETY INSTRUCTIONS
1. Do not use ‘split’ work pieces.
2. Always start at the lowest speed when starting a
new task.
3. Check that the tool rest is at or slightly below the
centre line of the workpiece.
4. Check the work piece is securely mounted in the
lathe before switching on the power.
5. Rotate the work piece by hand, to check that it
is centralised, clear of the tool rest, not ‘split’ or has
loose knots.
6. Where lathes have the facility to be reversed;
check the machine is rotating in the correct
direction.
7. If your lathe has the facility to run in reverse, you must ensure that the mounting accessories (chucks,
faceplates etc.,) can be ‘locked’ onto the lathe
mandrel, and in the case of chucks have some form of
security device to prevent them ‘unwinding’ during
reverse operation.
8. Make sure your tools are stored/racked away from
the turning area of the lathe. Do not reach over a
rotating work piece at any time.
9. Do not ‘dig in’ or try to take too large a cut.
10. Do not leave the lathe running unattended; or
leave the machine until everything is stopped.
11. Some turning tools may have specific sharpening
angles that have been determined by the
manufacturers; when re-sharpening, adhere to these
angles to maximise the finish of your work.