Axminster 107655, Оригинальное руководство пользователя

Страница: 11 / 60

REMOVING DRIVE/LIVE CENTRES
11
Figure 15 Figure 16
Centre hole in the headstock operating wheel Insert the push rod (C) through the
headstock and push the drive centre out
To remove the Drive Centre (A), locate the push rod (C), while holding the tool insert the push rod (C)
through the centre hole of the headstock wheel and push the drive centre out. (See figs 15-16-17)
Repeat the procedure for the Live Centre in the tailstock. (See fig 18)
Figure 17 Figure 18
Figure 18a
Removing the drive centre Live centre in tailstock
Loosen the two grub screws (D) on
either side of the faceplate boss
A
REMOVING THE FACEPLATE
C
Rotate the spindle until the machined hole on the
shaft lines up with the spindle collar access hole.
Insert the push rod (C) into the access hole, using a
Hex key loosen the two grub screws (D) on either
side of the faceplace boss. Place a spanner over
the faceplate boss and while holding the push rod
rotate the spanner anti-clockwise to remove the
faceplate,see fig 18a.
D
Spindle collar
Access hole