AXMINSTER WORKSHOP AW368WL, Оригинальное руководство пользователя

Страница: 8 / 28

ASSEMBLY / OPTIONAL ACCESSORIES ASSEMBLY
8
Fig 19-20-21-22-23
Locate the lathe bed extension (M) and the four cap head
bolts and washers. NOTE: the lathe bed can be mounted
in two positions. The first to the end of the lathe bed and
second mounted to the left leg stand (B) using the four
pre-drilled holes in the casting.
1. Remove the tailstock stop pin, to the left side of the
lathe bed. Screw in the four M10 bolts into the four
pre-drilled holes to the end of the lathe bed, see fig 19-20.
Leaving a gap between the bed face and the bolt heads,
lower the key slots in the extension bed (M) down over
the bolts until firmly seated, see fig 21-22-23.
NOTE: Don't
tighten at this stage.
Optional Lathe Bed Extension
Position One:
WARNING: THE BED EXTENSION IS HEAVY, IT IS
ADVISABLE TO SEEK HELP.
Stop pin
Motor/Power Cables
Two the side of the headstock assembly there are two
power sockets. Connect the motor plug to the top socket
and the 230V power cable to the lower socket,see fig 18.
Fig 18
Motor cable
230V cable
M10 bolts
Key slots
Setup 1
M