AXMINSTER WORKSHOP AW368WL, Оригинальное руководство пользователя

Страница: 18 / 28

OPERATING INSTRUCTIONS
18
Fig 58
3. Press down the motor assembly to retention the drive
belt with a slight defection, nip-up the locking handle to
secure the motor. Close the drive pulley access door and
lock in place, see fig 58.
CONNECT THE LATHE TO THE MAINS SUPPLY!
4. Start the lathe and increase the speed, check
everything is running correctly, no vibrations or
knocking sound for example. If everything is fine,
switch off the lathe and wait until the machine comes
to a complete stop.
5. Continue with operation.
Replacing the Drive Belt
Over a period of time check the drive belt for signs of
fraying, splitting or missing teeth. If any of the following
is evident, the belt will need replacing.
DISCONNECT THE LATHE FROM THE MAINS
SUPPLY BEFORE CONTINUING!
1. Open the drive pulley access door, insert the indexing
pin (I) into the top indexing hole (B) to the right side of
the headstock, locking the spindle in place, see fig 59.
Fig 59
I
B
2. Using a 12mm Hex key loosen the headstock wheel.
Unscrew the wheel from spindle assembly and place
safely to one side, see fig 60-61.
Fig 60-61
12mm Hex key
3. Remove the three screws holding Faceplate and place
it and the screws safely to one side, see fig 62-63.
Fig 62-63