Axis P1347, Руководство пользователя

Страница: 6 / 60

AXIS P1347 Network Camera
Hardware overview
Connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or required. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their speci fi c use. Make sure that the network switch is properly grounded. See
Electromagnetic Compatibility (EMC) for regulatory requirements.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in ampli fi er. A stereo connector must be used for the audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please refer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to
Setup
> System Options > Storage > SD Card
and click
Unmount
.
Control button - The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Connecting to an AXIS Video Hosting System service. See page 44 . To connect, press and hold the button for about
1 second until the Status LED fl ashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 44 . To connect, press and hold the button for
about 3 seconds.
• Resetting the product to factory default settings. See page 50 .
Power connector - 2-pin terminal block for power input.
I/O connector DC power input
Note
For technical speci fi cations, see page 56 .
I/O terminal connector - Use in applications for e.g. motion detection, event triggering, time lapse recording and alarm noti fi cations.
In addition to an auxiliary power and a GND pin, the I/O terminal connector provides the interface to:
6