6
AXIS P3301/AXIS P3304
Microphone -
built-in microphone. This can be disabled by inserting a plug in the 'Audio in' connector.
Power Connector -
for connection of the PS-H power adapter (included).
I/O Connector -
the I/O terminal connector provides the physical interface to one transistor output, one digital input and an
auxiliary connection point for DC power. For more information, see
The I/O Terminal Connector
, on page 41.
Network Connector -
The camera connects to the network via a standard network connector. Supporting NWay, the camera
detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). Supporting PoE (Power over Ethernet), the
camera can be powered directly from the network cabling.
Audio Out -
audio output (line level), which can be connected to a public address (PA) system or an active speaker with a
built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.
Audio In -
a 3.5 mm input for a mono microphone, or for a line-in mono signal (a stereo signal from line-in uses the left
channel).
Serial Number Label -
the serial number may be required during installation.
Control Button -
press this button until the status LED blinks green to install the camera using an AVHS service (see page
34), or the AXIS Internet Dynamic DNS Service described on page 35. To restore the factory default settings using the control
button, follow the instructions
Resetting to the Factory Default Settings,
on page 40.
LED indicators
LED
Color
Description
Network
Green
Steady for connection to 100 Mbit/s network. Flashes for network activity.
Amber
Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit
No connection.
Status
Green
Shows steady green for normal operation.
Note:
The Status LED can be configured to be unlit during normal operation, or to flash
only when the camera is accessed. See the online help files for more information. Go to
Setup > System Options > LED settings
Amber
Steady during startup, reset to factory default or when restoring settings.
Red
Slow flash for failed upgrade.
Power
Green
Normal operation.
Amber
Flashes green/amber during firmware upgrade.