SBC82621 Socket370 Half-size All-in-One CPU Card User’s Manual
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller
(FDC) installed on the system board and you wish to use it.
If you install and-in FDC or the system has no floppy drive,
select Disabled in this field. The options available are
Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first
and second serial ports. The options available are
3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART 2 Mode
The second serial port offers these infrared interface
modes:
IrDA
ASKIR IrDA-compliant serial infrared port
Normal (default value)
NOTE:
The UART Mode Select will not appear on the
menu once you disable the setting of
Onboard Serial Port 2.
When UART Mode Select is set as ASKIR or IrDA, the
options RxD, TxD Active and IR Transmittion delay will
appear.
IR Function Duplex
This item allows you to select the IR half/full duplex funcion.
TX,RX inverting enable
This item allows you to enable the TX, RX inverting which
depends on different H/W requirement. This field is not
recommended to change its default setting for avoiding any
error in your system.
Onboard Parallel Port
This item allows you to determine access onboard parallel
port controller with which I/O address. The options
available are 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7, Disabled.
Award BIOS Utility
45
