AXIOMTEK SBC8241, Руководство пользователя

Страница: 26 / 50

SBC8241 486 All-in-One Half-size User’s Manual
AMI BIOS Setup
#'
# .5+.%$4
$"FE5"6%%5$
"FE5"6%%5$
C5D$"FE5"6%%5$
*
#" Quick Boot
Set this option to Enabled to instruct AMIBIOS to boot quickly when the
computer is powered on. This option replaces the old Above 1 MB
Memory Test Advanced Setup option. The settings are listed on the
following page.
Setting Description
Disabled
AMIBIOS test all system memory. AMIBIOS waits up to
40 seconds for a READY signal from the IDE hard disk
drive. AMIBIOS waits for .5 seconds after sending a
RESET signal to the IDE drive to allow the IDE drive
time to get ready again. AMIBIOS checks for a <Del>
key press.
Enabled
(default)
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a READY
signal from the IDE hard disk drive. If a READY signal
is not received immediately from the IDE drive,
AMIBIOS does not configure that drive. AMIBIOS does
not wait for .5 seconds after sending a RESET signal to
the IDE drive to allow the IDE drive time to get ready
again.
#" BootUp Sequence
This option sets the sequence of boot drives (floppy drive A:, hard disk
drive C:, or a CD-ROM drive) where the AMIBIOS attempts to boot
from after AMIBIOS POST completes. The settings are C:,A:,CDROM
(default), CDROM,A:,C: or A:,C:, CDROM.
#" BootUp Num-Lock
Set this option to Off to turn the Num Lock key off when the computer
is booted so you can use the arrow keys on both the numeric keypad
and the keyboard. The settings are On (default) or Off.
#" Floppy Drive Swap
Set this option to Enabled to permit swapping between drives A: and B:.
The available settings are Enabled or Disabled (default).