SBC81613 Socket 370 All-in-One CPU Card Series User
’
s Manual
Installation
11
C h a p t e r 3
Installation
This chapter describes the hardware installation procedures on
the
SBC81613 Series
all-in-one Socket 370 CPU card. The
following is a list of typical peripherals required to build a
minimum system:
Power supply and passive backplane (optional)
IBM
™
PC/AT keyboard
Display monitor
Floppy or hard disk with MS-DOS or Flash Disk emulator
3.1 System
Memory
The
SBC81613 Series
industrial CPU card supports one 168-
pin DIMM (Dual In-line Memory Module) socket for a maximum
total memory up to 1.5GB SDRAM. The memory module can
come in sizes of 16MB, 32MB, 64MB, 128MB, 256MB and
512MB SDRAMs.
NOTE:
Use SDRAM modules with PC100 or PC133 specification
when running 100/133MHz CPU bus speed. With 66MHz
CPU bus speed, SDRAM modules with PC66, PC100 or
PC133 specification can be used. You have to install the
Intel Celeron or Pentium III processor before installing the
memory modules.
3.2 CPU
Installation
1.
Align pin one (e.g., white dot) of the CPU with pin one of
the socket. Pin one of the CPU socket may either be
marked on the board or indicated by an arrow head symbol
on one corner of the socket. Normally, its diagonal corner
distinguishes pin one on the socket.
2.
To complete the CPU installation, gently press the CPU
into place.
3.
Double-check the insertion and orientation of the CPU
before applying power. Improper installation will result in
permanent damage to the CPU.
