Axel Falcon 50 FM, Руководство по эксплуатации, Страница: 25 / 45

FIRST INSTALLATION RECOMMENDATIONS
ENG
Pag. 25
14.3 FUSE REPLACEMENT
The power supply socket has an integral fuse drawer containing the AC power fuse and a spare, both of the
same value.
BEFORE REPLACING THE POWER FUSE, MAKE SURE YOU HAVE THE RIGHT TYPE
OF FUSE FOR THE VOLTAGE TO BE PROTECTED.
USING WRONG FUSE TYPE WILL RESULT IN INSUFFICIENT PROTECTION.
Make sure that the power is switched off and the power cable is disconnected from the equipment.
Open the fuse drawer using a small blade screwdriver.
Replace the fuse located at the inner position
Push the fuse socket back into the original position
Perform the set-up under static control conditions. Static charges are likely to completely
destroy one or more of the CMOS semiconductors employed in the unit. Static damage will
not be covered under warranty.
Basic damage prevention consists of minimizing generation, discharging any accumulated
static charge on your body and preventing that discharge from being sent to or through any
electronic component.
Uninsulated dangerous voltage are inside the enclosure, voltage that may be sufficient to
constitute a risk of shock.
Always disconnect to AC Mains before removing the top cover
14.4 PROTECTION AGAINST LIGHTNING
Should the device be put out of action due to being struck by lightning or excess voltage,
disconnect it from the power supply without delay. Do not reconnect until the device has
been checked. If in doubt contact the technical support service.
Make sure there is suitable lightning protection to protect the device.
Alternatively you should disconnect all connectors from the device during a storm or when
the device is going to be unsupervised or not used for a longer period of time.
These measures will protect against damage by lightning or excess voltage.