- 36 -
SW1 - FUNCTIONS
In operation with relays, the configurations that can be programmed with the Dip Switch SW1 strip are:
INFRARED SECTION CONFIGURATION
DIP 1 OFF DEFAULT
In this configuration, the infrared section has a
default sensitivity
(studied
for standard use) and executes a
digital analysis
of the signals.
DIP 2 OFF
DIP 1
ON
LOW
in this configuration, the infrared section has a
low sensitivity compared
to the default
and executes a
digital analysis
of the signals
which is
more severe
than the default one and considers a
dual impulse.
DIP 2 OFF
DIP 1 OFF MEDIUM
in this configuration, the infrared section has a
medium sensitivity
compared to the default
and executes a
digital analysis
of the signals
which is more severe
than the default one.
DIP 2
ON
DIP 1
ON
HIGH
in this configurations, the sensor has a
high sensitivity
and detects
any
signal
analysing amplitude and frequency.
DIP 2
ON
MICROWAVE SECTION CONFIGURATION (only OUTSPIDER DT)
DIP 3 OFF DEFAULT
in this configuration,
the microwave section
executes a
digital analysis
of the signal.
DIP 4 OFF
DIP 3
ON
APPROACHING
in this configuration, the microwave section analyses the signal while
considering only the
movements approaching
the sensor
DIP 4 OFF
DIP 3 OFF MOVING AWAY
in this configuration, the microwave section analyses the signal while
considering only the
movements moving away from
the sensor
DIP 4
ON
DIP 3
ON
NO CONTROL
in this configuration, the microwave section detects any movement while
analysing the intensity and frequency of the signal.
DIP 4
ON
SENSOR OPERATION (only OUTSPIDER DT)
DIP 5
OFF
AND
the alarm is generated only when both sections (infrared and microwave)
detect the adequate signal
ON
SECURITY
(not recommended for
external use)
the sensor works in
OR integrated
; it therefore generates an alarm signal
even when the individual section detects a series of valid signals
DIP 6
NOT USED
DIP 7
NOT USED
DIP 8
NOT USED
NOTE: by default, the DIP SWITCHES are all positioned at OFF
The
DIP SWITCH
of the
SW 1
strip
change usage f unction based on
operational mode se in the sensor (DIP
1 of the SW 2 strip):
DIP/RELAY mode:
in this
mode the DIP
SWITCHES are used to configure
operation of the two section (infrared
and microwave) as shown on the table
at the side.
PC/BUS mode:
in this mode the DIP
SWITCHES are used to assign an
address to the sensor (see table on the
next page).
However, even in PC/BUS Mode is is
possi ble tempo rarily us e DIP
SWITCHES from SW 1 to configure the
two sections as if the DIP/RELAY Mode
was selected.
In order to do this, it is sufficient to:
1.
Set the DIP SWITCH according to
the desired configuration.
2.
Position DIP SWITCH 1 of SW 2
in the ON position.
3.
Bring DIP SWITCH 1 of SW 2 to
the OFF position.
4.
Position the DIP SWITCH of the
SW 1 based on the address to be
assigned to the sensor.
E
N
G
