- 31 -
Sensor opening and board removal
1.
To remove the cover,
first lift the bottom part
(
1
) and then unhook it
from the upper part of
the guide (
2
).
1
2
2.
Remove the
two set screws.
3.
Slide the board until the
notches
A
coincide with
the stops
B
.
4.
Remove the board.
A
A
B
B
Wall and pole plate installation
Holes for fixing the
plate to the wall
Holes for fixing the plate
to a pole with adaptor
mod. SP-OUT
(item 1135106)
Installation of the joint
Assemble and fasten
using the
Screw
D
and
the
Nut
E
the various pieces
that make up the joint, as shown
in figure, before fixing
the
Wall side bracket
A
to the wall.
A
B
C
F
E
D
ATTENTION
Before fixing the
wall joint, install the
anti-tampering
module
ATTENTION
Position the
Sensor side
joint
C
verifying that the
45° notch is on the
bottom and the 90° one
is on the top
For passing connection
cables and those of the
anti-tampering module,
use the existing space
above the
Screw
D
E
N
G
