MOUNTING AND INSTALLATION
This chapter describes the steps you have to perform to mount and install the Product in a correct and safe
manner.
These steps are subdivided into the following groups, each of which is described in a separate section:
1.
Mounting construction
2.
Connecting the Components to the Recorder
Take the following precautions to prevent the Product from falling down which may cause injuries:
• Set up this Product on a hard, stable surface, or mount it to a wall or ceiling.
• ONLY use an Avonic mount for mounting to a wall or ceiling.
• Ensure the mounting construction is capable of supporting four times the weight of the Product. (See
'General Specifications > Weight product’
in the Product Datasheet for the exact weight.)
• Use a safety loop or drop protection that prevents the Product from falling if the mounting construction fails.
• During mounting and installation, NEVER install a Product above a person.
• Check the installation at least once a year. An improper mounting could cause the unit to fall off, resulting in
personal injury.
Mounting construction
IF you decide to place the REC200 on a mounted construction, make sure that the REC200 is prevented from
falling by placing it on a hard stable surface that can carry its weight. See also
manual.
Connecting the Components to the Recorder
Execute the following steps to connect the components to the REC200:
1.
Connect all provided components (see
) to the ports at the back of the REC200. The
figure below shows the applicable ports.
2.
Connect an Ethernet cable to the RJ45 port (2) (not provided in the package).
3.
Connect a camera via a HMDI
IN
(6) or SDI cable (8) (not provided in the package) to the REC200.
Figure 5: REC200 Back
1. Power Supply Input
2. RJ45 network connector for streaming and management
purposes
3. HDMI loop output (connection to a monitor)
4. RS 232 input (future use)
5. Audio IN
6. HDMI IN
7. Close Caption over CVBS Input (NOT ACTIVE)
8. 3G-SDI IN (level A only)
9. SD card slot
4.
Wait until the REC200 is booted up. This process takes approximately 35 seconds to 1 minute to complete. After
that, follow the instructions in the
chapter in this manual.
14
