AVE-xx30-A User Manual | 28
Revision Date: 09/25/2021
REMOTE CONTROL BATTERIES
To install batteries in the remote control:
1.
Press down the tab on the cover plate and pull the cover plate up.
2.
Insert the included batteries. Ensuring that the polarities correctly match the (+) and (-)
markings inside the battery compartment.
3.
Insert the lower tab of the cover into the opening and press down the cover until it clicks in
place.
Notes on Batteries
•
Please only use approved AAA type batteries.
•
Do not mix an old battery with a new one or different types of batteries.
•
If you will not use the remote control for a long time, remove the batteries to avoid damage
from battery leakage.
•
Do not expose batteries to excessive heat such as from sunshine, fire, or the like.
•
Don’t recharge, heat, disassemble, short, or throw batteries into a fire.
Notes on Remote Control Operation
•
Make sure that there is nothing obstructing the infrared beam between the remote control and
the IR receiver on the display.
•
If the effective range of the remote-control decreases, or it stops working, replace the
batteries with new ones.
•
The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
•
Ambient conditions may possibly impede the operation of the remote control. If this happens,
point the remote control at the display, and repeat the operation.
Remote Control Sensor
The effective area of the remote control includes the vertical distance within five metres in front of the
display, and the area within an angle of 30 degrees from the vertical point to the left and the right.
