3
4
Setting up the Board and the PC
Please perform the following steps to setup the Zynq Mini-ITX board.
1.
Install a jumper on JP1 pins 1-2.
2.
Install a jumper on JP7 pins 3-4.
3.
Install a jumper on JP12 pins 2-3.
4.
Connect the USB A-mini-B cable to J7 and the USB port of the PC (USB-UART
connection).
5.
If not already installed, install the power module onto the Mini-ITX board via J8,
J9, and J10 connectors.
6.
Connect the ATX power supply to P2 connector.
7.
Connect the ARM DSTREAM adapter to the Mini-ITX PJTAG header (J11).
8.
Start a Tera Term session and set the serial port parameters to 115200 baud rate, 8
bits, 1 stop bit, no parity and no flow control (please refer to the
Setting up the
Host PC
section at the end of this document for installing the software driver for
the USB-UART port and setting up the UART).
