
15
3
Advanced settings
3.1
Personal Setup
In addition to its basic functions, the CD 30.3 has a wide range of options for individual
adaptation to your personal requirements. These functions are accessible via the
Personal
Setup menu. To call up the
Personal Setup
, switch off the CD 30.3 completely using the power
switch (23) on the back of the device. Now hold down the
PROG
key (4) and switch the unit on
again with the power switch (23). As soon as the display shows
*** personal setup ***,
the
PROG
key (4) can be released.
Use the two
INPUT
keys (2, 3) to select the desired setup point. Use the
SKIP
keys (11, 12) to
make the desired setting. Press the
STOP
keys (9) to exit the
Personal Setup
menu (
EXIT
).
Then the CD 30.3 must be switched off completely using the power switch on the back of the
unit (26) and switched on again after a short waiting period. The settings made are permanently
stored, but can be adjusted at any time by calling up the
Personal Setup
again.
3.1.1
Volume control
Choose between a fixed (
fixlevel
) or variable (
variable
) volume level of the analog outputs (14-
16). When selecting a variable output level, the volume of the analog outputs of your CD 30.3
can be adjusted by long pressing the <
INPUT
> keys (2, 3) or by using the
VOLUME
keys on
the RC 3 or RC 8 remote control. The RC 8 also allows you to mute / activate the outputs with
the
MUTE
key.
In the middle of the upper display line the current volume value is displayed (e.g.
VOL 75
). In
contrast,
FIX
indicates the selection of a fixed output level at the same position.
NOTE: If a digital input is selected where no valid signal is present (
NO DIG SIGNAL
), the
volume function is disabled.
3.1.2
Autoplay
If the
autoplay
function is activated, the unit will automatically start the playback process after
inserting a CD without the need to press the
PLAY
key first. If necessary, the unit will
automatically switch from the currently selected input to CD mode. This function is activated
(on) in the factory setting. If the
autoplay
off
setting is selected, the CD will be read after
insertion, but the drive will not play it automatically but will go into
STOP
state.
3.1.3
Skip unused inputs
If you do not need all digital inputs of your CD 30.3, the unused inputs can be deactivated
(
skipped
). When selecting the source, all inputs defined as
SKIPPED
are automatically skipped
and cannot be selected via remote control. The settings can be cancelled at any time by calling
up the personal setup again (
active
).
Содержание CD 30.3
Страница 1: ...Operating Instructions CD 30 3 ...
Страница 2: ......