
10
2
Operation
2.1
First power on / self test
If your CD player is completely disconnected from the power supply or switched off via the
power switch (23), a so-called self-test is performed after switching on the device. The device
checks the configuration and functionality of the installed components and then goes into
stand-by mode. This process may take a few seconds.
2.2
Switching device on / off
With the on / off key (1) you can switch between operation and stand-by mode. In stand-by
mode, the display (7) is deactivated and the operation indicator LED (6) lights up. As soon as
your CD player is in operation, the operation indicator goes out and the display is activated.
ATTENTION:
The device is not completely disconnected from the power supply in stand-by
mode. To disconnect the unit completely from the power supply, press the power switch (23)
at the back of the unit or pull the power cable out of the power socket (22).
2.3
Display
The display (7) shows you information about the current operating status of the CD player or
the digital input in D/A converter mode. In addition to the display of the selected source such
as CD player or digital input, the bottom line shows you the current settings of the D/A
converter: On the left side the sample rate (e.g.:
96
), on the right side the current filter setting
(
SMOOTH
or
STEEP
).
2.4
Volume adjustment: Fixed / Variable level
Depending on the selection of a fixed or variable volume level (see section 3.1.1), information
about the current volume setting of the CD 30.3 is shown in the middle/upper area of the display
(7).
VOL
indicates a variable output level, so you can adjust the volume of the analog outputs
of your CD 30.3 using the
VOLUME
keys on the RC 3 or RC 8 remote control or by pressing
the
INPUT
keys (2, 3) for a
long
time.
FIX
, on the other hand, indicates the selection of a fixed
output level at the same place.
NOTE
: When the variable volume setting is active, you can adjust the volume of the analog
outputs of your CD 30.3 using the
VOLUME
keys on the RC 3 or RC 8 remote control or by
pressing and holding the INPUT keys (2, 3).
Содержание CD 30.3
Страница 1: ...Operating Instructions CD 30 3 ...
Страница 2: ......