For the full manual, visit the link below:
avlite.com/product/product-page-url-NotTheDirectManualLink/
Quick Start Guide
AV-HL-FL
Thank you for purchasing this product.
This guide will
provide you with a brief summary of the steps involved in
deploying the AV-HL-FL.
The purpose of this Quick Start Guide is to present a brief summary of the steps involved in deploying
your Avlite provided floodlight. Your product will consist of a prewired and preassembled AV-HL-FL light
fixture (and solar assembly for solar variants) on a frangible mount assembly.
Heliport Flood Light AV-HL-FL
Avlite’s floodlight has been specifically designed for helipads to
provide uniform surface lighting where the TLOF and FATO lights
need to be supplemented with floodlighting. The fixture is available
in solar (PV) and wired versions (DC and Universal Mains UM).
Theory Of Operations
AV-HL-FL-PV model: The solar module of the light converts sunlight to an electrical current that is used to
charge the battery during daylight hours. The battery provides power to operate the light at night. For op
-
timum solar charge performance, it is recommended that the unit is orientated with the solar panels facing
East-West.
AV-HL-FL-DC and UM models: The wired fixtures are connected to one another as part of a daisy chain con
-
figuration where power, control and monitoring points are wired in parallel utilizing a single cable route per
lighting circuit and junction boxes per fixture. The HLS is controlled from a primary Helipad Controller which
provides power and state transitions to each connected lighting circuit.
Step 1: Install the LED Floodlight Units
and solar assembly (if required)
Set up a number of concrete pads at equidistant
points around the TLOF at ground level. The
concrete pads should have a dimension of
approximately 400mm x 400mm with sufficient
depth depending on soil conditions. Embed 4 bolts,
using the Mount Base as a placing template, fitting
level when dry. As an alternative, it is possible to
use rubber tiles instead of concrete pads.
LED Floodlight Unit - Side View
Solar Assembly - Front View
Repeat for installing solar assembly, which requires
two concrete pads with 400 mm between the
mounting centrepoints.
AV-HL-FL-PV model only: Connect the LED Flood
-
light Unit to the Solar Assembly using the Avlite
supplied 2m long cable.
