Avitech Sequoia 2H2U, Руководство пользователя

Страница: 20 / 55

15
To change the audio meter properties, perform the following steps:
Step 1. Click Meter . The Sequoia is capable of displaying embedded audio as VU (volume unit) meters
inside the video window. Embedded audio is divided into four groups, with a master and
secondary channel for each group. This allows you to display the left and right VU meter of
either the master or secondary channel on the left and right side of the window just as the menu
depicts. Along with the video signal(s), each input signal may contain up to sixteen channels (8
pairs) of embedded audio. Typically, 48kHz, 20-bit audio; (extendable to 48kHz, 24-bit audio).
Figure 2-22 Phoenix-G Software:
“Meter Properties – Module” Window
Step 2. Click the All button to display all meters or click the checkbox individually to display the desired
meter only ( Meter 1 L , Phase 1 , Meter 1 R , Meter 2 L , Phase 2 , Meter 2 R , Meter 3 L , Phase
3 , Meter 3 R , Meter 4 L , Phase 4 , Meter 4 R ). Click the Meter SW checkbox to open/close the
meter switch. Then click the Meter outside checkbox to enable the meter to be displayed
outside the image area.
“Meter outside” is not allowed if the image area is less than 140×64 pixels (does not include the window
border and label portions).