Avital AVISTART 4501, Руководство по установке

Страница: 9 / 28

Installation Procedures
Control Unit
1 . Select a location under the dash that will allow you to use the tie wraps to
securely fasten the control unit.
2 . Mount the control unit as high as possible to ensure maximum security.
3 . Do not mount the control unit near moving parts.
4 . Avoid areas that are in the direct path of air blowing from the vents.
5 . Route wires from this point, leaving slack for ease of service.
RangeMaster™ Super Heterodyne Receiver Module
1 . Plug the receiver module WHITE connector into the control unit WHITE
plug.
2. Use tie wraps to fasten the receiver module as far from the control unit as
possible.
3 . Route the antenna cable up through the driver side windshield pillar,
behind the headliner and behind the rear view mirror.
4 . Fasten the antenna to the windshield with the double stick tape supplied
with the antenna mask facing down.
NOTE: Be sure to clean the windshield before fastening the antenna.
Wireloom
1. Plug the wirelooms securely into the control unit and satellite relay
module.
2 . Route wires from the control module and satellite relay module directly to
each connection point.
3 . Separate the small and large RED , RED/WHITE , BLACK , TAN , and
WHITE/GREEN wires.
4. Sleeve these wires with vinyl tubing or electrical tape and route them
through an existing rubber grommet into the engine compartment.
5 . If an existing grommet is not available, drill a hole and install a snap
grommet.
7
AviStart 4501 Installation Manual - 0999