Avital AVISTART 4501, Руководство по установке

Страница: 11 / 28

Parking Lights
1 . If the parking lights are positive trigger, connect the RED/WHITE wire to
the battery positive (+) terminal through the 20 amp fuse assembly.
NOTE: Do not connect the RED/WHITE wire to the control unit RED wire.
2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire
to control unit BLACK wire.
3. Connect the RED/BLACK wire to the vehicle parking light wire.
Reverse Light
I
CAUTION : Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1 . Set the parking brake.
2 . Turn the ignition key to the "ON" position and adjust the gear shift selector
to "Reverse."
3 . Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle’s reverse light wire.
Interior Light Illumination
1 . Connect the WHITE wire to the vehicle door trigger wire.
2. If the door trigger is negative, connect the WHITE/BLACK wire to ground.
3. If the door trigger wire is positive switching, connect the WHITE/BLACK
wire to a fused constant +12 volt source.
Trunk Release
The DARK BLUE wire provides a 1 second ground output when the d button
is pressed for 1-2 seconds. If the d button is continually pressed, the output
will stay at ground as long as the button is held. Most factory trunk releases
are positive trigger and require an optional relay.
9
AviStart 4501 Installation Manual - 0999