Avital AviStart 4500, Руководство по установке

Страница: 10 / 24

2. If the parking lights are negative (-) trigger, connect the RED/WHITE wire
to control unit BLACK wire.
3. Connect the RED/BLACK wire to the vehicle parking light wire.
Reverse Light
I
CAUTION: Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1. Set the parking brake.
2. Turn the ignition key to the "ON" position and adjust the gear shift selector
to "Reverse."
3. Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle’s reverse light wire.
Interior Light Illumination
1. Connect the WHITE wire to the vehicle door trigger wire.
2. If the door trigger is negative, connect the WHITE/BLACK wire to ground.
3. If the door trigger wire is positive switching, connect the WHITE/BLACK
wire to a fused constant +12 volt source.
Trunk Release
The DARK BLUE wire provides a 0.75 second ground output when the
TRUNK button is pressed for 1-2 seconds. If the TRUNK button is continually
pressed, the output will stay at ground as long as the button is held. Most
factory trunk releases are positive trigger and require an optional relay.
Channel 5 Accessory
The LIGHT BLUE wire provides a 0.75 second ground output when the LOCK
and UNLOCK buttons are pressed at the same time for 1-2 seconds. If the
LOCK and UNLOCK buttons are continually pressed, the output will stay at
ground as long as the buttons are held. This output can be used for optional
accessories such as window roll-up/down or any other accessory requiring a
(-) activation.
8
AviStart 4500 Installation Manual - 0898 Rev. A