AVIRE AC-DAB10-120-F-0L-000 Скачать руководство пользователя страница 9

CAN D

A

U IG (A

U) V

01: EP 30

/04/20

20

ENVIRONMENT CONDITIONS

This device is designed to be used indoors (0

o

C to 45

o

C with relative humidity between 

20% to 80% not condensing). Sudden changes of temperature and humidity should be 
avoided.

CLEANING AND MAINTENANCE

Use a soft dry cloth. Do not use solvent or abrasive products.

SAFETY

Please read these safety instructions before starting the device.

 

+

Do not expose this device to liquids or excessive humidity. The DAU LPBus is an 
indoor device and is not waterproof

 

+

Do not expose the device to fire

 

+

Do not try to modify the device

 

+

Do not use the device in potentially hazardous areas or where there is risk of 
explosion

BATTERY

The DAU LPBus has a NiMH 3.6 V/650 mAh battery that allows it to keep functioning 
in the event of a mains power failure. This battery should be replaced every 2 years. 
Replacing the battery involves removing the lid of the DAU, disconnecting the existing 
battery and replacing it with the new battery from Avire (the part number is on the 
battery label). 

This battery should be properly recycled and not disposed of with unsorted household 
waste.

DISPOSAL

The device complies with regulations 2002/95/CE and 2003/108/CE regarding 
the use and disposal of hazardous substances in electric appliances.

Do not dispose of this device with unsorted household waste. Disposing 
of the device in an unauthorised way could result in a fine in line with local 
regulations.

ENVIRONMENTAL REGULATIONS

RoHS - Avire certifies that its production process complies with the 2011/65/EU 
European Directive of 3 January 2013 regarding the restriction of use of hazardous 
substances in electric and electronic appliances.

Avire Global Pte Ltd

Suite 39
110-116 Bourke Road
Alexandria
NSW 2015
Australia

T:

 02 9669 1102

E:

 [email protected]

W:

 www.avire-global.com

Avire Global Pte Ltd

Suite 39
110-116 Bourke Road
Alexandria
NSW 2015
Australia

T:

 02 9669 1102

E:

 [email protected]

W:

 www.avire-global.com

Содержание AC-DAB10-120-F-0L-000










Отзывы: