Avipas AV-1563, Руководство пользователя

Страница: 17 / 31

15
4. Network Configuration
4.1 Network Connection
Direct connection: Connect the camera and computer via an Ethernet cable directly.
Internet connection mode: Connect the camera to Internet (via a Router or a Switch).
The computer must be assigned to the network segment where the camera IP address belongs to. The
device will not be accessible otherwise.
The camera’s default IP address is 192.168.5.163, and in this case, your computer’s IP must be
192.168.5.xxx.
Open “Network and Sharing Center”, select “Ethernet”, “Ethernet Status”, “Properties”. Double click
“Internet protocol version 4 (TCP/IPv4)”. In the TCP/IPv4 Properties window; select “Advanced” to
access TCP/IP settings. Set computer’s IP, subnet mask and default gateway accordingly. Click the
“Confirm” to finish the adding of IP segment. If you’re using a camera with default settings, the
recommended settings for your computer is:
IP: 192.168.5.160
Subnet mask: 255.255.255.0
Default gateway: 192.168.5.1
Note: please make sure the IP address to be added is not the same as any other device connected
to your computer.
To verify the network segment has been successfully added, click “Search” icon and input “cmd”.
Then click “Command Prompt” and open DOS command window. Ping 192.168.5.26 and press Enter
key to display information as shown below:
Connect the camera to your computer, power on. Open DOS command window, and ping
192.168.5.163, then press Enter key.