Aviom AN-16/i-m, Руководство пользователя

Страница: 43 / 58

35 AN-16/
i
-M M
ic
i
Nput
M
odule
u
ser
G
uide
Connecting the System Bridge
Adding a System Bridge to a system is quite simple. Two System Bridges are
used to create a network The four A‑Net connectors (labeled A, B, C, and
D) on the one side of the network are directly related to the A, B, C, and D
connectors on the other side of the network. That is, if you patch an AN‑16/i
Input Module into port “A” on one side of a System Bridge, an AN‑16/o Output
Module would be connected to port “A” on the other side of the System
Bridge. See the following diagram.
AN-16/i-M
AN-16/o
A-Net Out A-Net In
A
B
C
D
A
B
C
D
Bridge
System Bridge System Bridge
This diagram shows the relationship of the A, B, C, and D ports on the AN-16SB.
A complete network using four units per side follows the same pattern. A
Pro16 input module connected to port B on one side of the network connects
to an AN‑16/o Output Module via port B on the other side of the network.
The same goes for ports C and D, as seen in the following diagram.
AN-16/i
AN-16/i
AN-16/i-M
AN-16/i-M
AN-16/o
AN-16/o
AN-16/o
AN-16/o
A-Net Out
A-Net In
A
B
C
D
A
B
C
D
Bridge
System Bridge System Bridge
A-Net ports A, B, C, and D shown connected in a 64 x 0 network configuration
To connect a 64 channel network (64 x 0):
On the Send side
Connect a Cat‑5e cable from the A‑Net Out of the first 1.
Pro16 input module to port A on the first System Bridge.
Repeat this process to connect the A‑Net out from the
2.
remaining three AN‑16/i or AN‑16/i‑M Input Modules to
ports B, C, and D.
On the Receive side
Connect a Cat‑5e cable from port A on the second System 3.
Bridge to the A‑Net In jack on the first AN‑16/o Output
Module.