CRANE Co.
280N MIDLAND AVENUE, STE.258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.avidcontrols.com
01/05/2018
TECH-537/ D.W.O. 23142
Page 19 of 21
Appendix: B
Trouble shooting guide for Calibration Error Messages
TRANSDUCER ERROR
When preforming an
Auto Calibration
if the LCD shows “TRANSDUCER ERROR” within 2 minutes.
The transducer is not connected to the EaziCal II.
UNABLE TO CLOSE
When preforming an
Auto Calibration
and within 2 minutes the LCD displays “UNABLE TO
CLOSE”. The air supply is not connected or turned on.
CURRENT OUT OF RANGE
Input current set too high for Low current Calibration
.
When preforming an
Auto Calibration for Low Current
and within a few seconds the LCD
displays “CURRENTS OUT OF RANGE”. Set the loop current to the desired Low Current value.
Input current set too low for High current Calibration
.
When preforming an
Auto Calibration for High Current
and within a few seconds the LCD
displays “CURRENTS OUT OF RANGE”. Set the loop current to the desired High Current value.