Avid Technology DSI-192, Руководство по установке

Страница: 15 / 21

S6L Stage I/O Card Installation Guide 10
8
Inside the back of the unit, push the latches on the newly installed card outward (open).
9
Connect (or reconnect) ribbon cable(s).
• Locate the corresponding ribbon cable (all ribbon cables are cut to length), and push the cable connector into the port on the
card so that the latches on the port move inward and lock the connector to the port on the card. Double-check to make sure the
card is connected securely.
• If you had to disconnect other ribbon cables, re-connect them starting with the first (shortest) ribbon cable.
10
Replace the back panel on the Stage 64 or Stage 32:
Stage 64 Make sure to properly orient the panel, align the back panel guide pins to the guide holes, and secure it to the Stage 64
by tightening the captive thumbscrews.
Stage 32 Make sure to align the back panel and secure it to the Stage 32 by tightening the captive thumbscrews.
11
Proceed to “Confirming Installation” on page 11.
Figure 10. Connecting the I/O card to its corresponding ribbon cable in Stage 64 (shown at left) and Stage 32 (shown at right)
Figure 11. Back panel guide pins (Stage 64 only)