PT
HD SDI Megapixel PTZ Dome Camera Instruction Manual
22/72
Check Points before Operation
Before turning on the system, check if the wire(s) and cable(s) are connected properly.
Check if the camera ID on the controller is properly selected. The camera ID must be identical to that
of the target camera. The camera ID can be checked by reading the DIP switch of the camera or on
OSD.
If your controller supports multi-protocols, the protocol must be changed to match to that of the
camera.
Adjust the DIP switch after turning off the camera. If you changed the camera protocol by changing
the DIP S/W, the change will be effective after you reboot the camera.
Since the operation method can be different by controllers, refer to your controller manual if the
camera can not be controlled properly. The operation of this manual is based on the standard Pelco®
Controller.
Check Points for Preset and Pattern Function before Operation
Check fully how to operate preset function and pattern function with your controller or DVR in
advance to operate the camera functions when using a controller or a DVR.
Refer to the following table when using standard Pelco® protocol controllers.
< Go Preset >
Input [Preset Number] and press [Preset] button shortly.
< Set Preset >
Input [Preset Number] and keep pressing [Preset] button for more than 2 seconds.
< Run Pattern >
Input [Pattern Number] and press [Pattern] button shortly.
< Set Pattern >
Input [Pattern Number] and keep pressing [Pattern] button for more than 2 seconds.
If your controller or DVR has no pattern button or function, use the Hot Keys with preset numbers.
For more information, refer to
Reserved Presets(Hot Keys)
in this manual.
OPERATION
3