AVGear AVG-UHMS44PRO, Руководство пользователя

Страница: 16 / 37

AVG-UHMS44PRO
5.1.4. Clear Operation
When you accidently switch an output channel, learn EDID data, or set EDID data,
press the
Clear button to cancel
the operation before you press “
ENTER
”. When you
press it, the matrix will return to the previous state.
5.2. IR Control
By using IR & HDBaseT transmission technology, the AVG-UHMS44PRO has the
following functions:
1. Control a far-end output device from the local matrix location.
2. Control a local input/output device from a remote location.
3. Control the AVG-UHMS44PRO locally/remotely.
5.2.1. Usage of the IR Remote
1. Standby button, press it to enter/exit standby mode
2. Input channels, range from 1~4 (buttons 5~8 are not
available), corresponding IR signal switched
synchronously when switching input channels.
3. Menu buttons, ALL , EDID and CLEAR , have the
same functions as the front panel buttons. Please
refer to
4.1 Front Panel Button Control for details.
4. : Navigation buttons.

ENTER: Confirm button.
5. OUTPUTS (buttons 5~8 are not available)

In normal mode: output channel selection
buttons, each channel has 1 IR IN, 1
HDBaseT, 1 RS232, and 1 AUDIO outputs,
and channel 1~4 have HDMI outputs.

In EDID programming mode: press button
1/2 to switch among the 5 embedded EDID
data
Note:
With this IR remote, the AVG-UHMS44PRO can be controlled by the built-in
IR, the extended IR receiver connected to the “IR EYE”/”IR ALL IN” and the IR
receiver on the far-end receiver.