Avery Weigh-Tronix TT-830, Руководство по обслуживанию

Страница: 26 / 50

26
TT-830 Bench Scale Service Manual
• the tension frequency (Ft) and compression frequency (Fc)
(Each should be as stable as the other and within 10% of
each other. As weight increases the tension count should
increase and the compression count should decrease.)
• Cell size (30Kg for example)/Display resolution for maximum
efficiency (10000 is shown)
• Software version of the cell (vD.A in this example)
For analog bases you are shown:
• a raw count value and its equivalent mV/V value. (These
values should be positive and increase as weight is applied.
SERIAL Use this to test your ports. Select Port #1 or 2 then short the TX
and RX on the selected port. The display will change from NO
LOOP to LOOP indicating the port is good.
Port 1 is Comm1, a 9-pin connector. Short pins 2 and 3 for
Loop/No Loop test. Short pins 7 and 8 for Ready/Busy test.
Port 2 is Comm2, a 15 pin connector. Short pins 3 and 5 for
Loop/No Loop test on RS-232-A. Short pins 2 and 5 for Loop/No
Loop test on RS-232-B.
Port 3 is the local Quartzell. Use the local base test to verify
current cell communication.
MORE Accesses the following keys:
INPUTS The same as Outputs except you are activating an input set-
point device such as a switch or contact closure remotely and
monitoring it with this menu.
OUTPUTS Allows you to Activate/Deactivate any output setpoints you are
using on the SSCU8 to verify correct hardware operation during
installation or for troubleshooting purposes.
DISPLAY This test continuously cycles the display through various pat-
terns.