Avery Dennison Cutter 2000, Техническое руководство

Страница: 8 / 17

03/10 Rev. 5.04-01 TECHNICAL MANUAL Connection, Setup, Service
Cutter 2000
8
[1] Unmount the cutter to clean the light sensor (1).
«
Check, if the cutter cable is damaged. If so, replace the cable.
«
Adjust the oscillator disc (see section “Oscillator disc” – “Setting the oscillator
disc”).
P
A complete description of all parameters can be found in the printers user
manual, topic section "Info Printouts and Parameters".
P A list of all status reports can be found in the printers user manual, topic
section “Status Reports”.
Parameter settings
The following parameters govern the cutter function and may need to be
adjusted:
P For more detailed information, see the chapter "Info Printouts and
Parameters".
¯
After a print job has been downloaded, the programmed cut function is
carried out automatically by the device.
TTX 350 TTK 64-xx AP 7.t AP 5.4/5.6 Meaning
PEPH PEPH Peripheral
device Peripheral
device Peripheral
device Selection
parameter for
peripheral
devices
CSPD CSPD Cut speed Cut speed Cut speed
CPOS CPOS Cut position Cut position Cut position Cut position
CWID CWID Cut width Cut width Cut width
CDIS CDIS Double cut Double cut Double cut Double cut
function
CMOD CMOD Cut mode Cut mode Cut mode Cut mode
[Tab. 1] Parameters which are important for the cutter function.
™