03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
16
Accessories
Stripper plate
If the applied label material is very thin and flexible, it may happen, that the
label material is drawn upwards together with the ribbon, instead of being fed
into the cutter.
The stripper plate avoids this effect.
[1]
The stripper plate is a simple plastic strip, which is supplied with adhesive foil on one side.
Assembling
1. Dismantle the cutter from the printer.
2. Clean the rim (1) – best by means of some cleaning fuel.
3. Remove the cover paper off the stripper plate.
4. Glue the stripper plate (2) to the rim as illustrated (see Fig. 2 right side).
[2]
Middle: Clean the rim (1) with cleaning fuel. Right and left sides: Glue the stripper plate
(2) justified to the one edge – the stripper plate should loom above towards the paper-
insertion side.
P
The part numbers of the stripper plate can be found in topic section "Spare
Parts", section "Accessories".
Abstreifer/
Stripper plate
Z0164.cdr
