03/10 Rev. 5.04-01
TECHNICAL MANUAL
Connection, Setup, Service
Cutter 2000
4
System requirements
Cutters in the appropriate width can be operated with the following printers:
System Requirements
Preparation for peripheral devices
For using the printers with a cutter, they must be especially equipped
(Tab. 2). This so called peripherals preparation consists mainly of an additio-
nal output stage board for the motor of the peripheral device and of some ad-
ditional connection cables.
Peripheral test
TTK/TTX 350:
«
Set parameter
SYSP > PEPH
to KNIF.
If the printer displays the status message ST68 after the ENTER key is pres-
sed, the peripheral board is not installed. If ST68 does not appear or if a dif-
ferent status message is displayed, then the printer has been set up for
peripheral devices.
64-xx / AP 5.4 / AP 5.6 / AP 7.t:
«
Make a service status printout: Call parameter
PRINT INFO > Service Status
.
64-xx and AP x.x printers are equipped with peripheral preparation if the topic
“Peripheraldriver” can be found below the header “Peripheraldriver” on the
printout.
Printer
Cutter width
64-04 / TTK / TTX 350 / AP 5.4 / AP 7.t
4"
64-05
5"
64-06
6"
64-08
8"
[Tab. 1]
The cutter width must match the printwidth of the printer.
Printer
Peripherals preparation
64-xx
optional
TTX 350
optional
TTK
standard
AP 5.4/5.6
standard with printer version „Peripheral“
AP 7.t
standard
[Tab. 2]
Only the TTK is in any cases equipped with the peripheral preparation. For the
other printer types this is an option.
