Avere FXT 5000 Series, Руководство по обслуживанию на месте

Страница: 28 / 48

FXT 5000 Series Field Service Guide
Read Replacing a Single System Drive (page 24) for the steps to replace one failed system drive.
Read Replacing Both System Drives (page 25) for the steps to replace a pair of failed system drives.
Before replacing a failed system drive, review the following warnings:
• Hazardous Energy Levels (page 5)
• Service Area Clearance (page 6)
5.3.1 Replacing a Single System Drive
To replace a single failed system drive on an FXT 5000 Series node, you only need to remove the faulty drive and
install the new one. No reformat process is required, and the node does not need to reboot.
Follow these steps.
Tip:
Drives numbered 6 and 7 are system drives.
1. Unlatch and eject the drive
As shown in the following illustrations, press the maroon button on the drive assembly of the failed drive to
release it. A black lever is released from the front of the drive assembly. Grasp the lever of the drive assembly
and rotate it out to eject the drive.
Unlocking a drive
2. Remove the drive
Use the lever to pull the drive assembly from the node chassis. Note the number on the label applied to the
assembly lever.
From the set of labels that is supplied with the replacement drive assembly, select the label with the same num-
ber as the drive being replaced. Apply the numbered label to the lever of the replacement drive assembly in the
same orientation and the same location as the original label. Press the label firmly to make sure that it sticks
to the drive. See
FXT 5000 Series Front and Rear Illustrations (page 10) for an illustration of how drives are
labeled.
24 Chapter 5. Replacing Failed Drives