Aventics PROFINET-IO, Руководство по эксплуатации

Страница: 92 / 348

Commissioning and Operation
92 AVENTICS | PROFINET-IO | R412015162–BDL–001–AE
6.1.2 Setting the diagnostic messages
The S3 mode switch used to set the diagnostic messages is
located under the PG fitting A (see Fig. 6 and Fig. 7 on page 88).
When delivered, the diagnosis is deactivated (S3.1 – 3.6 set
to OFF)
O
Activate or deactivate the diagnostic message to the
IO controller with switches S3.1 – 3.6.
The modified switch position will only be activated after
a new “power on”.
The queued diagnoses are shown on the LEDs of the
BDC-B-DCP_32 even if the diagnostic message on the
IO controller is turned off!
Table 19: S3, defining the monitoring threshold for valve voltage
Bit 8 7 6 5 4 3 2 1 Meaning
3.1 OFF Valve driver diagnosis switched off
ON Valve driver diagnosis switched on
3.2 OFF Low voltage message U
Q1
switched off
ON Low voltage message U
Q1
active
3.3 OFF Low voltage message U
Q2
switched off
ON Low voltage message U
Q2
active
3.4 OFF Message U
Q1
missing switched off
ON Message U
Q1
missing active
3.5 OFF Message U
Q2
missing switched off
ON Message U
Q2
missing active
3.6 OFF SREG short circuit message off
ON SREG short circuit message active
3.7 OFF U
Q1
tolerance - 15%
ON U
Q1
tolerance - 10%
3.8 OFF U
Q2
tolerance - 15%
ON U
Q2
tolerance - 10%