Installation Guide
Hybrid Towel Ladders – Non Heated
Models: Hybrid 420, Hybrid 720, Hybrid 1020, Hybrid 1320
Version: 5.01
www.avenir.com.au
OVERVIEW
Thank you for choosing AVENIR Bathroom Accessories and for supporting a 100% Australian designed and manufactured product.
PLEASE TAKE NOTE: The installation procedure for Avenir products may be different from other products and may not be common knowledge.
Please read this installation guide carefully. Experience has shown that most issues arise as a result of either our installation procedure not being
followed or the supplied fixings not being used. Please use the supplied fixings as they have been carefully selected and tested to suit the
application. Our warranty covers only manufacturing and workmanship defects, not application suitability or issues with installation.
AVENIR Hybrid towel ladders are designed to suit stud walls with tiles or masonry walls. Non-masonry walls with no tiles will require a
timber substrate directly behind each point where the ladder is fixed to the wall. In this case follow the procedure below, with the
exception that no wall plugs are required.
SAFETY
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure they do not play with the appliance.
INSTALLATION PROCEDURE – NON HEATED TOWEL LADDERS
Step 1
•
Apply the supplied double-sided tape to the MDF mounting template and remove the backing.
•
Using a spirit level, stick the template squarely to the wall at the desired location.
•
Using an 8mm bit and the MDF mounting template as a guide, drill four holes in the wall surface to a
depth of 40mm.
•
Remove the mounting template and double sided tape.
Step 2
•
Insert the 4 supplied wall plugs into the holes in the wall.
•
If necessary use a sharp blade to trim the wall plugs so that they are flush with the wall surface.
•
Fasten the four mounting legs to the wall using the 4 supplied large stainless steel screws. Note the
orientation of the mounting legs and the position of the screws in the diagram.
Step 3
•
Remove the plastic protective film from the towel ladder prior to installation.
•
Loosen the four grub screws on the reverse side of the ladder (2 turns only).
•
Slide the left and right aluminium covers towards the top of the ladder so that the top fixing holes are
visible.
•
Using 4 supplied small stainless steel screws; attach the aluminium covers to the top mounting legs.
Step 4
•
Slide the heated towel ladder upwards until the bottom fixing holes on the aluminium covers are visible.
•
Using 4 supplied small stainless steel screws; attach the aluminium cover strips to the bottom mounting
legs. Slide the heated towel ladder downwards until the left and right towel ladder side channels are flush
with the aluminium covers at the top and the bottom.
•
Lightly tighten the 4 grub screws at the rear of the ladder – only tighten until the top of the grub screw is
flush with the surface of the aluminium covers.
•
Fit the 4 chrome caps to the ends of the towel ladder side channels.
Step 1
Step 2
Step 3
Step 4
