Avdel Genesis G3, Инструкция по эксплуатации

Страница: 12 / 106

Stem Deflector
Extension
Side Ejector
Accessories
12
ADAPTOR NUT
71210-20101
STEM DEFLECTOR
07340-00342
The stem deflector is a very simple alternative to the standard
stem collector and allows access in restricted areas. To replace
the stem collector with the stem deflector proceed as follows:
•
Unscrew retaining nut 21 by inserting a 3 millimetre diameter
rod into one of the holes.
•
Remove retaining nut
21
and the stem collector assembly,
items
15
,
16
,
17
,
18
,
19
, and
20
.
•
Screw the adaptor nut onto end cap 22 .
•
Push the boss end of the stem deflector into the internal
groove of the adaptor nut.
•
Rotate the stem deflector until the aperture faces away from
the operator and other person(s) in the vicinity.
Item numbers in bold refer to the general assembly drawing and parts list on pages 22-23.
INNER
71210-20301
OUTER
71210-20302
STEM DEFLECTOR: 71210-20100
EXTENSION: 71210-20300
INNER
EXTENSION
OUTER CASING
8-32 x
1
/
4
" SOCKET
CAP HEAD SCREW
Part number: 07498-00900
for fasteners with a stem larger than 3.1 mm ( 1 /
8
") Ø
Fitted between the tool and the nose assembly the extension
allows access into deep channels.
•
To fit the extension, remove any nose assembly
components.
•
Screw the inner extension to jaw spreader housing
1
.
•
Screw the outer onto head assembly 4 .
•
Fit the nose assembly onto the extension.
Fitted between the tool and the nose assembly, the side ejector
forces fastener stems to eject at the front of the tool and
reaches into deep channels.
It cannot be used in conjunction to a swivel head. Select the
correct part number (below right) according to the stem
diameter of the fastener.
For greater ease of use, it is recommended that the stem
collector or deflector is replaced with safety cap part number
71210-20201 as used with swivel heads. See page 14 for fitting
instructions, but note that the stop nut is not fitted in this case.
•
To fit the side ejector, remove any nose assembly
components.
•
Remove the socket cap screw from the side ejector.
•
Screw the inner extension onto jaw spreader housing 1 .
•
Screw the outer casing onto head assembly 4 .
•
Replace the socket cap screw securing with Loctite
Screwlock 222, part number 07900-00371.
•
Screw the nose assembly onto the side ejector.