Removing transceivers
Remove transceivers by performing this procedure.
1. Disconnect the network fiber cable from the transceiver.
2. Use the locking mechanism on the transceiver to release it. The locking mechanism varies
from model to model as illustrated below.
3. Slide the transceiver from the port.
4. If the transceiver does not slide easily from the port, use a gentle side-to-side rocking motion
while firmly pulling the transceiver from the port.
5. Attach a dust cover over the fiber-optic bores and store the transceiver in a safe place until
you need it.
Important:
Discard transceivers in accordance with the proper laws and regulations.
Console port pin assignments
The following section describes the console pin assignments for the RJ-45 connectors in the Avaya
Virtual Services Platform 7200 Series.
Table 17: Console port pin assignments
Connector
Pin Number
Signal
1
Ready to send (RTS) — optional
2
Data terminal ready (DTR) — optional, can swap or link with pin
8
3
Transmit data (TXD) — mandatory
4
Carrier detect (DCD) — optional
5
Ground (GND) — mandatory
Table continues…
Console port pin assignments
November 2016
Installing the Avaya VSP 7200 Series
73
